| Jetway NF9VT Mini-ITX Motherboard |
| Processor | Intel® Celeron N2930 SoC, 1.83GHz – 2.16GHz Burst, Quad-Core, 7.5W TDP/4.5W SDP |
| Memory | 1 x 204-pin DDR3L-1333 SO-DIMM up to 8GB (1.35V required) |
| Graphics | Intel HD Graphics, 313MHz - 854MHz |
| Audio | Realtek ALC662 2.1 Channel HD Audio with 3W Amplifier |
| LAN | 1 x Realtek RTL8111G Gigabit Ethernet with Enhanced Surge Protection |
| Storage | 1 x SATA2 3Gb/s Connector
1 x mSATA (Full size) |
| Super IO | FINTEK F81866A |
| Back Panel Connectors |
1 12V DC-In jack
1 PS/2 Keyboard/Mouse
1 USB 3.0
3 USB 2.0
1 RJ45 LAN (10/100/1000)
1 RJ-11 port (+12V/+24V)
4 RJ45 Serial Ports (cables not included)
|
| Onboard I/O Connectors |
1 PCI Express x1 Slot
1 Full size mSATA Slot
1 Full size mini PCI-E Slot
1 SATA2 3Gb/s Connectors
2 USB Pin Headers for up to 4 additional USB 2.0 Ports
2 Serial Port Headers (1 * RS232, 1 * RS232/422/485)
1 24-bits Dual Channel LVDS connector/Inverter
1 PenMount C8051F321 Touch IC 5-wire Resistive
1 AT/ATX power switch mode select jumper
1 Chassis Intrusion Header
1 VGA Header
1 Parallel Header
1 SMBUS(I2C) Header
1 8-bit GPIO Header
1 9-pin Audio Header
1 2-pin LAN LED Header
1 Front Panel Header
3 Speaker Header, Mic Header, Line-out Header
3 Fan Headers
1 2-pin MON_PWR Out Connector
1 2-pin +12V Alternate Power Connector (Molex 5566-2)
|
| Power Supply for NF9VT |
External Power Supply – the board can be powered with a 12V external power supply though a DC connector on the back panel. The rear 12V DC jack accepts plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is 12V and the shell is GND.
Internal Power Supply – the board can alternatively be powered via the internal 12V DC 1 x 2 power connector, where pin 1 is GND and pin 2 is +12 (±10%) VDC. The internal 1 x 2 power connector is a Molex 5566-2 header which accepts a Molex 5557-02R connector from the power supply.
Caution: There is no isolation circuitry between the external 12V DC jack and the internal 1 x 2 power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external 12V DC jack is covered if the internal 1 x 2 power connector is to be used.
|
| Market Segments Supported |
√ Digital Security & Surveillance
√ All-in-One (AIO)
√ Panel PC
√ Industrial Automation/Control
√ Retail (POS/Kiosk/ATM)
√ Thin Client
|
| Environment |
Operating Temperature : 0 ~ 60°C
Storage Temperature : -20 ~ 85°C
|
