| Model Name | NF731V |
| Part Number | JNF731V-3955U |
| Form Factor | 3.5" SBC (148 x 102mm) |
| Processor | Fanless Intel® Celeron 3955U, Skylake-U 15W Processors
* Ships with flat heatsink installed for direct attaching to chassis |
| Memory | 1 x 260-pin SODIMM un-buffered DDR4-2133 up to 16GB |
| Graphics | Intel HD Graphics |
| Audio | NA |
| LAN | 1 x Intel i219-LM PHY Gigabit LAN
3 x Intel i225-V 2.5GbE |
| Storage | 1 x SATA3 6Gb/s Connector
1 x mSATA |
| Super IO | FINTEK F81768D |
| TPM | Intel fTPM 2.0 (PTT) Trusted Computing Firmware
OEM Option: Onboard TPM v2.0 |
| Back Panel Connectors |
1 Serial Port (RS232)
3 RJ45 LAN Port (100/1000/2500)
1 RJ45 LAN Port (100/1000)
2 USB 3.0
1 +12V 2.5mm Diameter Locking DC Power Jack
|
| Onboard I/O Connectors |
1 SATA3 6Gb/s Connector
1 mSATA Slot (Full-size)
1 Mini PCI Express Slot (1 * Full-size, for 3G/LTE Modem Card)
1 Mini PCI Express Slot (1 * Half-size)
1 Serial Headers (RS232/422/485)
2 USB Pin Headers for up to 3 additional USB 2.0 Ports
1 19-pin HDMI 1.4 Header (4096 * 2304 @ 24Hz)
1 SIM Card Socket
1 8 bit GPIO Header
1 AT/ATX Mode Jumper
1 Chassis Intrusion Header
1 7-pin PS/2 Mouse/Keyboard Header
4 2-pin LAN LED Header
1 5-pin SMBUS Header
1 4-pin Fan Header
1 4-pin Floppy Power Output (Male)
1 2-pin +12V Alternate Power Connector
|
| Power Supply for NF731V |
External Power Supply – the board can be powered with a +12V external power supply though a locking DC connector on the back panel. The rear +12V DC jack accepts locking plugs with an inner diameter (ID) of 2.5 mm and an outer diameter (OD) of 5.5 mm, where the inner contact is +12V and the shell is GND.
Internal Power Supply – the board can alternatively be powered via the internal +12V 2-pin power connector, where pin 1 is +12V and pin 2 is GND. The internal 2-pin power connector accepts a JST VHR-2N or TE 1-1123722-2 plug from the power supply.
Caution: There is no isolation circuitry between the external +12V DC jack and the internal 2-pin power connector. It is the system integrator's responsibility to ensure no more than one power supply unit is or can be attached to the board at any time and to ensure the external +12V DC jack is covered if the internal 2-pin power connector is to be used.
|
| Market Segments Supported |
√ Networking/Storage Server/Mail Server/Print Server
√ Industrial Automation/Control
√ Medical
√ IoT
|
